Blín D'ñero Forums

I never tested it with prime 95 before either.

I guess a simple way to figure it out would be to put xp on and then run prime95. Though that takes time.

all bought brand new two years ago. So, I guess it''s my old computer.

as for the CPU support, yes, I know it's suporrted. No clue why I get the same issues as that link. Temps for cores are the same as the casing temps, so I am assuming I am not getting the faulty temp display issue.

So - the motherboard doesn't support the cpu - - and to get it to work stable you need to in effect underclock and lower the voltage... The same thing I did. So. Should I take this a hint that this may be the highest I can go? Now. would it be worth while trying out a new cpu? I don't think I can re...

ya, no dice. Tried a bunch of combinations. can get it to start as low as 13 x. but nothing stable. anything less and it wont start, or I get BSOD and that's even with trying at a low speed of 3.0 Ghz for example 230 and 13x. if it's a heat issue, and I get a new heat sink, then pump up the voltage,...

I didn't assemble everything myself the cpu and cooler were assembled by the shop I bought it from. I have since took the cooler off, cleaned it, reapplied thermal paste and attached it back on. From what I can tell it's on good. drop the voltage?. K. It's at 1.3 right now. I can drop it more. I'll ...

I get errors at 1.3v I just it was better for temps. I think I found the issue. Droped clock ration from 15.5 to 15 4sticks @ 200 CPU frequency cpu voltage 1.3v clock ratio 15x 6-6-6-18 rowcycle 24 Trfc 195ns managed to get prime 95 to run for 3hours and 59 mins, then it crashed. Most people recomme...

... K, new issue Check out my temps using "CPUID hardware monitor" and core temp 0.99.8 they say that I'm running really hot, like 70-80 C on my cores... My max range is 55-63 c So I check my voltage. by default it's set to 1.4v however. with my cpu AMD athlon 64 x2 6000+ brisbane The volt...

tried upping the ddr voltage. nothing.

as for voltage

as per this
https://www.samsung.com/global/system/bu ... rev102.pdf
pg 13

recommended voltage of 1.9 max.... absolute maximum of 2.3

I think I may just end up taking it to the shop. The guy I bought it from has a degree in computer engineering. Is there a way of testing if it's a bus issue? I tired using only one ram in each. 1 and 2 were fine, 3 and 4 came back with errors. I'm not sure if that's really an error though. I could ...

So... we know the answer. It's setting the 4 ram sticks in. 2 sticks with 2008 works perfectly. they pass both memtest 86 and memtest. I can also play that demo now without issues. I guess the only other thing to test would be if i can do the same with the 2010 memsticks. I bet you I can. So if that...